Showing posts with label christmas stocking. Show all posts
Showing posts with label christmas stocking. Show all posts

Tuesday, December 20, 2011

Pom-poms and Glitter glue!

      Today I added some glitz to the stocking I made a few days ago.  I thought a pom-pom would look fabulous on the hanger-loop.  And of course I wanted to personalize it with my nieces' name.  That way Santa know's it's her's!  I didn't want to go too overboard, so I left it at that. 
WHAT YOU'LL NEED: 
- Yarn
- Scissors
- Cardboard
- Pencil
- Glitter glue


Directions:
       Use a round cup that is around 3.5 inches in diameter, and trace four circles onto a piece of cardboard.  In the center of two of the circles draw a smaller circle, then draw two lines about 1/4 inch apart coming down from the inner circle to the outer circle.  Cut out all four larger circles.  Now take the two circles you drew the smaller circles on, and cut out the smaller circles including the notch you made in the outer doughnut.  Place one of the doughnuts down with the cut-out facing you.  Cut a piece of yarn about 12 inches long, place the piece of yarn on top of the doughnut going around the inner circles, with the two ends coming down where the notch is.  Then place the other doughnut on top of the first doughnut, sandwiching the yarn in-between. 
                                                                                               
               


       Now start wrapping yarn around both pieces of cardboard.  I started in the center with the end on outside edge coming down the front, then wrapping around the backing.  Continue wrapping to the right, when you reach the end go back over the right, then down the left.  When you reach the bottom of the left side come back up to the center, and end here with the tale on the outside edge.   

      Next place the whole thing down and with one hand hold the piece down, then run the scissors between the two pieces of cardboard at the top edge cutting the yarn.  Once you've cut all the way around tie the 12 in. length of yarn tight, make as many knots as you feel necessary.  Remove the cardboard doughnuts.  


     Take the two cardboard circles you haven't used yet, and sandwich the yarn between the two.  Pin the cardboard in place with your largest needle in the center.  Trim any of the strings that seem too long.  

     Remove the cardboard, and then fluff up the pom-pom.  I used the tail to tie the pom-pom onto the stocking.  

     After all that hard work I played around on a piece of scrap fabric that matched the stocking.  I used my favorite tool - glitter glue, and tested the way the different glitter looked on the fabric, and with the font I used looked.  I picked my favorite look (with some help from my husband and mom), and wrote out Annabel's name on the stocking.  

Friday, December 16, 2011

Christmas Stocking

We have a new family member this year, little Annabel (my niece) was born November first.  Thus we need a stocking for her!  Instead of going the easy route (and buying one), I decided to make her a stocking.  I've never tried this before so I learned a lot along the way, but the end result is lovely.  

WHAT YOU'LL NEED:
  • 2 different types of fabric (about 2 ft. square)
  • Batting (about 2 ft. square)
  • White faux fur material ( about 2 ft. long, 4 in. length)
  • Ribbon (4 in)
  • Scissors
  • Marker
  • Needle & thread
  • Straight pins

Directions:
      Fold your fabric in half, and use an old stocking as a template.  Place the heel of the stocking against the fold in the fabric, and begin tracing.  After tracing the stocking cut out both pieces of fabric.  Now flatten out one of the pieces you've just cut out and use it to trace out the batting.  Once you've cut out the batting, you can cut the white fur for the top cuff, and the ribbon for hanging the stocking. 
     Now you'll want to layer all your pieces together.  First you'll start with the fur trim, fur facing down, then the ribbon folded in half in the center.  Then the fabric for the interior of the stocking with the front facing down.  Then the batting, and then the outside fabric facing up.  You'll want to pin the whole stocking together now.  Make sure at this point that you've layered everything correctly, remembering that you will be turning it right side out after sewing.  
      Now you can start sewing, begin going across the top with the stocking open flat.  Once you've finished the top you will fold the stocking in half and re-pin it together.  Now sew the whole stocking together, making sure to go thru all the layers as you go.  Once you are done turn it right side out.  


      Congratulations, you just made your first Christmas stocking!


Check back tomorrow, we'll be adding a little more glitz to this stocking.  Until then, happy DIYing!